Heating

Furnace won’t turn on? Safe checks before you call

Some no-heat calls turn out to be a switch, a filter, or a thermostat setting. These checks are safe for most homeowners and help a technician if you do need one.

A furnace that won’t start is frustrating, especially on a cold morning. Before calling, a few safe checks can either solve the problem or give a technician useful information.

First, safety. If you smell gas, don’t do any of the checks below. Leave the house, call your gas utility or 911 from outside, and don’t return until it has been checked.

1. The thermostat

Confirm it’s set to Heat and that the setpoint is a few degrees above the current room temperature. If the screen is blank, replace the batteries. If the thermostat has a schedule, make sure a schedule isn’t holding a lower temperature.

2. Power to the furnace

Most furnaces have a service switch nearby that looks like an ordinary light switch. It’s easy to turn off by accident. Make sure it’s on, then check the breaker panel. If the furnace breaker has tripped, reset it once. If it trips again, leave it off and call.

3. The front panel

Furnaces have a safety switch that cuts power when the blower door is removed or not seated properly. If someone recently changed the filter, make sure the panel is fully closed.

4. The air filter

A badly clogged filter can make the furnace overheat and shut itself off as a safety measure. If you can’t see light through the filter, replace it.

5. The status light

Many furnaces have a small window showing a blinking light on the control board. The pattern is a fault code, and the key is usually printed on the inside of the panel. Write down the pattern before doing anything else, because turning the power off and on clears it.

6. Drains on high-efficiency furnaces

If your furnace vents through white plastic pipe, it produces water. A clogged condensate drain or trap can stop the furnace from running. Water around the unit is a sign to mention when you call.

When to stop and call

  • You smell gas or notice a burning smell.
  • A breaker trips again after one reset.
  • The furnace starts, then shuts off repeatedly.
  • The status light shows a fault code you can’t clear by fixing one of the items above.

Furnaces have several safety controls for good reason. If one keeps shutting the system down, it’s doing its job, and the cause needs to be found rather than bypassed.

When it stops working, call.

Tell us what the system is doing. We’ll tell you what we think is happening and what a visit involves.

Service area
Irving, Las Colinas, Coppell, Farmers Branch, Grand Prairie, Euless, Bedford, Grapevine
Call now Contact